Except slot number 10 and 11, insert one side slot number 12 and the other side slot number 16 of the smallest coil.
Insert one side of the largest coil in slot number 1 and the other side in slot number 9.
Excluding Except slot number 1, insert one side slot number 2 of the same size of the larger size and the other side slot number 8.
Excluding Except slot numbers 1 and 2, insert one side slot number 3 of the smallest coil and the other side slot number 7.
The order of inserting the running coils into slots.
Slot number 28,29,30,34,35, the fourth set of coil in 36 will be released.
First set of coils in Islot number 1,2,3,7,8,9.
The stator of 36 slots has to put 12 coils in 24 slots. If the winding is to be done with a wooden firm, then make the firm winded according to the size.
Similarly, prepare three sets of three-three coils of the same size for the remaining three poles. In this way, a set of three coils of running winding of one pole is prepared These three coils are linked to each other in the series.
Also do not cut this wire after the turn is completed, but like the previous wire, the same wire was placed around the nails for the largest coil.
Do not cut the wire after the turn is completed, but wrap the desired turn around the nails attached to the coil for a larger coil.
Now turn the clock wise desired turn towards all the four. Leave a wire of about one foot and wrap it on the nail.
Now according to the size of the largest size slot number 1 and 9, put four nails on the same board.
After this, according to the size of slot number 2 and 8 larger than this, place four nails on the same board.
If the nails have to be made in form, first of all, put four nails on a flat wooden board according to the smaller size ie slot number 3 and 7.
First decide which method to wind the coil.
Similarly, count slot number 5 to 10 slot.
Measure the distance between these slots in a similar way, to remove the size of the coil, as it was earlier.
Now count slot number 2 to 7 except slot number 1, the count will come to slot number 8.
Keep the length so that the coil does not come out of the body of the motor.
Increase the length of the coil slightly from the length of the core.
Thewidth of the size of the coil will be a bit larger than the measured size.
Measurethe distance between these two slots with the compass.
Release slot numbers 1 and 2 to measure.
running pitch is 5-7-9 to measure the running coil.
It is convenient to consider the middle slot at the bottom of the stator as the number one.
To make a coil, first consider any one slot of the stator as number one.
The pitch shows that the number of running coils in a pole is three and the number of starting coils is 2.
Suppose the qualification for running and starting winding of 36 slots, 4 pole motor with running pitch 5-7-9 and starting pitch 8-10.
In the stator of a single phase motor, first running winding and later steering winding are put.
The coils are winded according to the size of the pitch.
The same applies for both starting and running windings.
So naturally the size of the coals also varies.
The number of coils in a pole is different, ie the size of pitch and the number of turns of the wire.